Estimados, buenas tardes. Le cuento que tenemos un problema donde digamos que el DAG perdió la red de backup (192.168.x.0) y no se la puedo volver a asignar ya que dejó de aparecer de la lista desplegable. Por ende, al no poder agregar esa red, no se pueden ejecutar los backups.
Encuentro los siguientes errores con sus ID:
ID 1196 - Clus
ter network name resource 'Cluster Name' failed registration of one or more associated DNS name(s) for the following reason:
DNS bad key.
Ensure that the network adapters associated with dependent IP address resources are configured with at least one
ID 1129 - Cluster network 'Cluster Network 3' is partitioned. Some attached failover cluster nodes cannot communicate with each other over the network. The failover cluster was not able to determine the location of the failure. Run the Validate a Configuration wizard to check your network configuration. If the condition persists, check for hardware or software errors related to the network adapter. Also check for failures in any other network components to which the node is connected such as hubs, switches, or bridges.
Cluster network interface 'SERVERMBX01 - BackupNetwork' for cluster node ' SERVERMBX01' on network 'Cluster Network 4' failed. Run the Validate a Configuration wizard to check your network configuration. If the condition persists, check for hardware or software errors related to the network adapter. Also check for failures in any other network
ID 1123 - Cluster IP address resource 'IP Address 192.168.2.210' cannot be brought online because the cluster network 'Cluster Network 3' is not configured to allow client access. Please use the Failover Cluster Manager snap-in to check the configured properties of the cluster network.
Para este ID voy a la opción (Allor clients to connect….) , y luego de tildar la casilla y dar ok, al hacer propiedades nuevamente lo veo DEStildado.
Bienvenida es la ayuda.
Saludos Juan Ramirez
Juan Ramirez - Soporte Técnico